GOST Phantom Sensors & Motion Detectors
 

GOST Phantom Sensors & Motion Detectors

High Water Sensor, Low Voltage Sensor, Tempsensor, Deck Pressure Sensors, Wireless Delay, Infrared Beam Sensor, Snap Canvas Snap Sensor, Door/Hatch Sensor, Standard Wide-Gap Extension Sensor, Super Heavy Duty Wide Gap Extension Sensor, Recessed Extension Sensor, Standard Wide Gap with Hidden Wire Extension Sensor

GMM-IP67-Heat : Heat Temperature Sensor

The GMM-IP67-Heat wireless Heat Temperature Sensor is designed to monitor the temperature inside the vessel's food, ice storage & bait freezers and will alert up to 8 people with a voice phone call and/or text message if the temperature reaches 160°F (+/- 5.4°F) and will reset when the temperature reaches 130°F (+/- 10°F). The IP-rated, wireless, battery powered GOST Heat Sensor is available as an add-on to any GOST Phantom, GOST Insight HD or GOST NT-Evolution System.

GMM-IP67-Heat

GMM-IP67-IBS : Infrared Beam Sensor

The GMM-IP67-IBS wireless Infrared Beam Sensor is designed to protect the exterior of the vessel. There is an invisible infrared beam shot between the emitter and the detector (photoelectric eyes). Once the infrared beam is broken the sensor is activated and causes the system to go into alarm. These sensors are commonly installed in the gunwales to protect the cockpit areas. Other uses include open fly bridges to protect the electronics or any other exposed areas where a motion detector is not practical. These sensors have a built in fail safe amplifier and are resistant to sunlight and other interference. These sensors are also available with 2 sets of photoelectric eyes.

GMM-IP67-IBS1

GMM-IP67-IBS2

We have also just released a new version of this sensor that has an output to connect an external siren.

GMM-IP67-IBS1-Siren-Out

GMM-IP67-IBS2-Siren-Out

GMM-IP67-IBS-Infrared-Beam-Sensor

GMM-IP67-HWS : High Water Sensor

The GMM-IP67-HWS wireless High Water Sensor is designed to stand up to the harsh marine environment and includes a mounting bracket for the float switch that should be installed in the bilge of the vessel slightly below the vessels factory installed high water sensor.

GMM-IP67

GMM-IP67-LVS : L12/24 - Low Voltage Sensor

The GMM-IP67-LVS wireless Low Voltage Sensor is designed to stand up to the harsh marine environment and is set to trigger an alarm when the voltage drops below 11.6v (on 12V Sensor) or 23.2v (on 24v sensor) for more than 2 minutes. This sensor will monitor any 12V or 24V battery bank. There is a dip switch on the circuit board that allows installers to switch the voltage monitored between 12 or 24 volts DC.

GMM-IP67-LVS : L12/24 - Low Voltage Sensor

GMM-IP67-TempSensor

The GMM-IP67-TempSensor wireless Temperature Sensor transmitter enclosure is designed to stand up to the harsh marine environment and is set to trigger an alarm when the temperatures exceed or drops below a preset temperatures range. The coil sensor itself can be mounted virtually anywhere in the vessel where temperature threshold alarms are needed.

GMM-IP67-TempSensor

GMM-IP67-DS : Deck Pressure Sensors

The GMM-IP67-DS wireless Deck sensor is designed to protect the exterior or interior of the vessel. The sensors are epoxied to the underside of the vessel's deck where they cannot be seen by intruders. In addition, they will not detract from the vessels decor. These sensors are effective on almost any boat structure including wood, fiberglass and even aluminum or steel decks. Environmentally sealed and utilizing 22-gauge marine grade wire leads, these sensors are ideal for those hard to protect areas of the vessel where there is access to the underside of the deck. They will not respond to vibration, shock, or airborne items. They sense only the unique flexing of the deck caused by a person walking. Sensitivity is fully adjustable from the processor. They can even be used to protect ladders up to the fly bridge or tuna tower.
Read more..

GMM-IP67-DS

GMM-IP67-RLY-Z1 : Water resistant wireless relay

The GMM-IP67-RLY-Z1 is the water resistant version of the RLY-Z1 above and is for use on the exterior of vessels, or on vessels where everything has the potential to get wet, like on a center console.

GMM-IP67-TempSensor

GMM-IP67-Pull-25 : Pull Sensor

The GOST GMM-IP67-Pull Sensor is a great sensor with multiple uses. Notification is given if the boat is pulled away from the dock, or the back of a yacht. It is also possible to install the sensors in several different ways. They can be installed with the female end on the dock or the mother ship, or they can have the male & female on the same vessel, which lends itself to more versatility. The sensor will cause the security system to go into alarm if the sensor is either pulled out or cut without first disarming the system. We designed this sensor to combat thieves coming up to vessels when they are tied up at night and cutting the lines and towing the vessel away with jet skis or other small watercraft which we have seen an increase in recent months.

GMM-IP67-Pull-Sensor

GMM-IP67-Snap : Canvas Snap Sensor

The GMM-IP67-CSS wireless Canvas Snap Sensor is designed to stand up to the harsh marine environment and is set to trigger an alarm when the canvas cover is unsnapped. The canvas snap sensor is mounted in an existing snap location by drilling a 25/64" hole thru the vessel. The sensor is inserted in the drilled hole and secured with the brass nut on the underneath side. An O-ring under the snap base provides a seal to keep water from entering around the sensor head. This sensor is great for protecting vessels that are covered with a canvas cover. Because of its exceptional design, it is impossible to see, as the sensor looks like a normal snap when properly installed.

GMM-IP67-Snap

GMM-IP67-DC : Water resistant door/hatch sensor

Our long range water resistant wireless door/hatch sensor works with any of our available extension sensors below. It is compatible with the GOST Phantom, GOST Phantom Insight HD Systems & GOST NT-Evolution. This wireless design also has a built in anti-tamper switch.

Features:

  • Wireless range in a typical marine environment: 35m (115ft) with GOST Phantom or GOST Phantom Insight HD that can be extended to 70m (230ft) with the Wireless Repeater
  • Low battery and signal transmission LED

Read more

GMM-IP67-TempSensor

GDC-EXT-WG : Standard Wide Gap Extension Sensor

Miniature Surface Mount Switch Set Wide Gap up to 3 inch gap between sensor and magnet (white).

GDC-EXT-WG

GMM-IP65-RP:

The GMM-IP65-RP is a water resistant wireless repeater that doubles the wireless range of the GOST Phantom (up to 250ft). This device can come in handy on 80+ foot vessels where diamond plating, metallic sound proofing, or multiple bulkheads may diminish wireless range on board or if the boat is made of metal. It operates on 433 MHz and is fully compatible with the full line of wireless sensors, relays, and/or keypads. The unit is housed in its own water resistant IP enclosure, complete with a Lead Acid battery backup, 6 ft power cable, and an AC transformer. The GOST Phantom is compatible with up to a maximum of four repeaters which lends itself well for large aftermarket mega & superyacht installations.

GMM-IP65-RP

GP-Commercial-RP-240 VAC

GP-Commercial-RP-120 VAC

The GOST Phantom Commercial Repeater is an IP rated wireless repeater that comes in a heavy duty fiberglass enclosure with 240 or 120 VAC power supply and battery back up. This device will double the wireless range of the GOST Phantom (up to 250ft). This device is typical used on 80+ foot vessels where diamond plating, metallic sound proofing, or multiple bulkheads may diminish wireless range on board or if the boat is made of metal. It operates on 433 MHz and is fully compatible with the full line of wireless sensors, relays, and/or keypads. The unit is housed in its own water resistant IP enclosure, complete with a Lead Acid battery backup, 6 ft power cable, and an AC transformer. The GOST Phantom is compatible with up to a maximum of four repeaters which lends itself well for large aftermarket mega & superyacht installations.

GP-Commercial-RP-240-VAC

GMM-IP67-Freezer : Freezer Temperature Sensor

The New GMM-IP67-Freezer wireless Freezer Temperature Sensor is designed to monitor the temperature inside the vessel's food, ice storage & bait freezers and will alert up to 8 people with a voice phone call and/or text message if the temperature rises to 39°F (+/- 5°F). The IP-rated, wireless, battery powered GOST Freezer Sensor is available as an add-on to any GOST Phantom, GOST Insight HD or GOST NT-Evolution System.

GMM-IP67-Freezer

GDC-EXT-WGHD : Super Heavy Duty Wide Gap Extension Sensor

Exterior Surface Mount Switch Set *SUPER HEAVY DUTY* up to 3 inch gap between sensor and magnet

GDC-EXT-WGHD

GDC-EXT-R : Recessed Extension Sensor

Miniature Surface Mount Switch Set Wide Gap up to 3 inch gap between sensor and magnet (white)

GDC-EXT-R

GDC-EXT-WGH : Standard Wide Gap with Hidden Wire Extension Sensor

Miniature Surface Mount, Wide Gap (white) Hidden Wire (bottom)

GDC-EXT-WG-NO